Universal M25-XP Alternator Support Arm Failure - Again

Twice in the past 7 years, I have purchased a pair of OEM Support arms for our Alternator on our Universal M25-XP Diesel engine, I have one left and have no reason to think that it will last as long as the others, in other words, failure is imminent. 

When they fail, they break near the top attachment slot and, luckily, it has not been a disaster. When they break, the arm falls down about an 1/8" of an inch, not much, but enough for the arm to rub against the Coolant piping and the potential rupture of the pipe and consequential loss of engine coolant. That could be a disaster.

I went to a local machine shop and described the problem and taking the last remaining arm with me to use as a template.

My request was to double the thickness of the arm from 3/16" to 3/8" and to expand the width at the slotted end by a 1/4" They did a great job.

The Gray arm is the original

The Original is laying on top of the new arm

Just spent a few minutes cleaning the surfaces with a nylon sanding pad, clean with Acetone and  then a couple of coats of spray High Heat Resistant Rust-oleum paint followed by a couple of coats of Rust-Oleum Metallic paint ( just happened to have some of that on the shelf) .  

L-to-R Original, Primed, Finished

Should be able to get down to the boat on Friday to install one, the second piece will get wrapped with clingfilm and stored on the boat with all of the other engine spares.

They were not cheap! The new arms cost $150 for one and $200 for two, but they now have a Drawing of them incase anyone wants one or two.

If you want one ( or two) reach out to them. The invoice number is 25326 for reference.

Tropic Marine Products

217 SW 29th Street

Fort Lauderdale FL 333015

Phone: 954-779-7038

I'm not getting any compensation for promoting these, but I know that so many Universal M25-XP owners have had similar issues.  

See you on the water.