Final Part of the Victron Power Management System Install

Mounting the Victron GX 4G LTE Modem & GPS Antenna

The Victron system installation has been working great for nearly a month now. It communicates with the Victron VRM on the Internet via a GX 4G LTE Modem. That has a small Stick Antenna and I was not happy with having that in the open down in the cabin, too great a risk that someone might nudge it and thus disconnect us from the net or worse, damage the modem. I had a Remote Antenna from a Wilson Cellular Extender that never worked well on our previous boat so I replaced the Stick Antenna with the Extension Antenna - Worked great when I left it just sitting on the shelf above the Nav Table until verified it worked ok.

Similarly, the GPS puck which connects to the 4G LTE Modem was just sitting on a shelf above the Nav Table,

The Pic shows the two cables from the GX 4G LET Modem (that's the unit with the blue light) 

Today I relocated the Antenna and GPS Puck to their permanent location. 

All I have left to do is run the wires from them to the LTE Modem. That should tidy up the installation significantly. I also replaced the 5m Network Cable from the Cerbo GX to the Victron Mk3 - USB interface with a .9m cable and, again, vastly improves the cable management.

Just to brag a bit, here's a screen shot of my Laptop at home showing part of the VRM data display.

Next job on the boat is to loom the new VHF Cable and the new gWind Transducer cable into the existing looms to secure them in place.  We're close to taking the boat out for an overnight really soon.

So, "See you on the Water" is not an empty promise.